Power steering cooler placement. Attach the 90 Degree side of the lines to the cooler.

Power steering cooler placement If a customer chooses to replace the factory grill with an aftermarket grill that does not include the mounting points for the power steering cooler, it is very important to get the cooler as close to its original position as possible. Check Installation as Follows: 1. Attach the 90 Degree side of the lines to the cooler. D) Connect remaining cooler hose to power steering unit. The engine compartment is a poor location since under hood temperatures can exceed that of the power steering ˜uid. Bolt the cooler into place and tighten all nuts and bolts. 1 Power Steering Cooler Tube Modification-Option 1 Drain the fluid from the PS reservoir using a Mighty Vac or similar siphon pump as shown in Photo 8-A. You will want to keep the lines together and route underneath the frame of the 8. The longer line will route to the power steering reservoir. Proper cooler placement also has to do with where and how the cooler is mounted. Hence, it is always important to place the cooler in a location where it will have access to the coolest air. Operate engine at fast idle for Learn How to Install a Power Steering Cooler in minutes! Any Vehicle with Rack and Pinion Power Steering will follow this concept, making this easy to under After mounting the cooler and hooking up the hoses you will need to fill up the power steering fluid reservoir and start the car. Route to the lines proper locations. Leave the short section of rubber hose that is connected to the reservoir and the cooling pipe as seen in Photo 8-C, it will be used on the reinstallation. Disconnect low pressure return line from power steering unit (Figure 2). There will be a huge air pocket in the system where the new cooler is, and where fluid has leaked out. The cooler should In addition to the air dam problem, sometimes power steering coolers are mounted to the grill of a vehicle. . C) Using the Quick-Connect, splice the return line and cooler hose together. 7. The shorter line will run to the power steering rack. B) Cut cooler hose for connection to return line. Tighten hose clamps. sab cjaw kqznv vxyzvzw dmp uiwjczp vhfxi eaqgg cfiqle grrw